POWAIR0012 EN
Copyright © 2018 VARO P a g e | 4 www.varo.com
Automatic lubrication is also possible using the supplied mini oiler that you have to install
between the threaded connector of the tool and the male coupler. Make sure that the oiler
is always filled with suitable oil.
Fig. 1
1. Tool
2. Quick connector
3. Quick coupler
4. Air hose
5. Quick connector
6. Quick coupler
7. Lubricator
8. Regulator (0-8.5 bar)
9. Filter
10. Cut-off valve
11. Air compressor
8 LOADING AND OPERATION
▪ Before each use, drain water out of air compressor tank and condensation from air
lines. After clearing air compressor moisture and lubricating the tool, connect it to an
air hose of a recommended size.
▪ Depress the trigger to remove or install the parts.
8.1 Fitting abrasive cutting discs (Fig. 2)
CAUTION! Always disconnect the tool from the source of compressed air
before fitting or removing an abrasive cutting disc.
Maintain a firm grip on the compressed air line in order to prevent whiplash when you
disconnect the quick-release connector.
▪ Hold the spindle in place with the spindle wrench and remove the spindle screw with
the Allen key as shown.
▪ Place a suitable abrasive cutting disc (available from auto accessory stores) on to the
spindle, making sure that the directional arrow on the abrasive cutting disc (if
applicable) agrees with the direction of rotation marked on the tool.
▪ Place the flange on to the abrasive cutting disc as illustrated.
▪ Hold the spindle in place with the spindle wrench and replace/re-tighten the spindle
screw with the Allen key to secure the abrasive cutting disc and the flange in place.
8.2 Changing abrasive cutting discs (Fig. 2)
▪ Disconnect the tool from the source of compressed air. Maintain a firm grip on the
compressed air line in order to prevent whiplash when you disconnect the quick-
release connector.
▪ Remove the abrasive cutting disc you no longer wish to use from the spindle.
▪ Subsequently fit the new abrasive cutting disc (available from auto accessory stores)
to the spindle as described above.
8.3 Switching the cut off tool ON/OFF
▪ To switch ON: Push the trigger lock and depress the trigger
▪ To switch OFF: Release the trigger
WARNING! Do not over tighten the parts.
