POWE80050 EN
Copyright © 2018 VARO P a g e | 5 www.varo.com
▪ Press the spindle lock button(12) and loosen the flange nut using the pin spanner.
Remove the diamond cutting discs and the spacer rings.
▪ Place one diamond cutting disc onto the motor flange.
▪ Slide space rings (as required) followed by the remaining diamond cutting disc on the
spindle.
▪ Press the spindle lock button(12) and screw the flange nut onto the spindle using the pin
spanner.
▪ Rotate the depth stop upwards, and replace the depth stop
▪ Put screws back in place using the hex key. (Caution! Do not forget the washer and lock
washers replace the depth stop fixing screw)
7 DEPTH ADJUSTMENT (FIG. 5)
▪ Loosen the fixing screw for depth stop (4)and set the require depth.
▪ Re-tighten the fixing screw for depth stop select a chase depth approximately 3mm deeper
that the actual required depth to compensate for unevenness in the wall surface.
8 TURNING THE MACHINE ON/OFF (FIG. 6)
▪ Press the safety switch (10) and pull the trigger(3) ,the machine is on.
▪ Release the trigger ,the machine is off.
▪ The machine fitted with a soft start mechanism
▪ The machine has an overload protection device. In case of overload, it will shut down
automatically. Release the trigger and remove the machine from the work-piece. Allow to
cool for a few minutes, then restart and run the machine at no-load for approximately one
minute to cool the machine down faster.
9 ADJUSTING THE CHASE WIDTH (FIG. 7 - 9)
▪ The machine is supplied with two spacer rings (10mm and 15 mm). The chase width is
adjusted by varying the amount of spacer rings between the diamond cutting discs. Mind
the width of the diamond cutting discs. The maximum chase width is approximately 29mm.
▪ Make sure at least 5mm thread remains to tighten the outer spanner ring.
10 DUST EXTRACTION (FIG. 10)
The wall slotter is equipped with a dust extractor socket. You can connect your vacuum
cleaner to the socket at the rear of the wall slotter. If you require a special adapter, please
contact the manufacturer of your vacuum cleaner.
11 OPERATION (FIG. 11)
Mark the line of cut before starting work, hold the machine tightly with both
hands.
▪ Set the chase depth, press the front edge of the depth stop, firmly against the wall. Switch
the machine on and gently lower the machine towards the wall until the rotating diamond
cutting discs plunge into the wall ,Hold the machine tightly with both hands.