Bedienungsanleitung ProfiCook PC-GG 1261 (Seite 21 von 24) (Deutsch, Englisch)

814405

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

PC-GG1261_IM_03.2023_new 08.03.23

Connecting the Appliance

Spider’s webs and insects can block the burner or pipe. Before connect-

ing, make sure that the burner and the burner ports are clean.

You will nd the gas connection on the right hand side of the appliance

level with the adjustment knobs.

• Select a suitable wrench and tighten the coupling nut (attention: left

thread) of the hose on the barbecue.

The screw connections of the hose must be securely connected to the

appliance and the low pressure regulator.

Finding Areas with a Bad Seal

CAUTION: Before use, check to make sure there are no areas

with a bad seal.

• Never look for sections with a bad seal using a naked ame.

• Use a leak detection spray or soapy water.

Please refer to the adjacent

illustration. Sections with a bad

seal soon become apparent in

soapy water. You need approx.

50 ml in a mixing ratio of 1:3

(liquid soap : water).

1. Make sure that all adjustment

knobs are in the 12 o’clock

position (OFF).

2. Once you have connected all

components as described above, turn the gas on.

3. Spread the soapy water on the hose and all connections. If bubbles

appear at a particular point, the section has a bad seal and it must be

repaired before use.

4. Repeat the test after the repair.

5. After the test, shut the valve on the gas cylinder.

If you nd a section with a bad seal that you cannot repair, refer the prob-

lem to a gas technician.

Operating the Gas Barbecue

CAUTION:

If the hood is closed, only barbecue at the setting LOW!

NOTE: When using for the rst time

Before preparing food for the rst time:

Close the lid and let the gas burn at a LOW setting for 15 minutes.

The smells from the treated surface are eliminated by the high temper-

ature.

Installation Site

The barbecue is for outdoor use only. During use, always place the barbe-

cue and the gas cylinder on even, stable ground. The surface should also

be heat-resistant, as the appliance emits a lot of heat during operation.

CAUTION:

The gas bottle must not be placed underneath the barbecue during

operation.

• The appliance should be protected from drafts and dripping water (e. g.

rain water).

• Remove combustible materials within a radius of 3 m.

• Make sure there is clearance of at least 1 m around the rear and side

walls of the appliances.

• There should not be any obstructions above the barbecue, because of

the rising heat.

• In order to not obstruct the ventilation, do not cover the barbecue in any

way.

If You Notice the Smell of Gas

1. Close the gas valve on the cylinder.

2. Extinguish naked ames and do not use electrical devices in the vicinity.

3. Ventilate the area.

4. Look for areas with a bad seal (as previously described).

5. If you can still smell gas, refer to your dealer or gas specialist.

Switching the Gas Barbecue On

1. Before igniting the burner, open the hood of the barbecue.

2. Press and turn both knobs clockwise to the 12 o’clock position (OFF).

3. Connect the gas hose to the gas cylinder and the barbecue.

4. Shut off the gas supply on the gas cylinder.

5. Is the system properly sealed? Check the connections for leaks using

soapy water or leak detection spray.

CAUTION: Always start with the left adjusting knob / burner 1!

The other burner is then also ignited by pressing the ignition button.

Press the left adjusting knob and then turn it anticlockwise to LOW as

far as it will go.

7. Press the small ignition button between the two adjusting knobs. You

should be able to hear a CLICK noise. The left burner 1 is ignited.

8. Whilst turning the adjustment knob further in the direction HI, check

whether the ame is burning. Otherwise, repeat the process.

9. If the burner still does not ignite, wait 5 minutes and repeat from step

6 onwards.

10. If the burner does not ignite, contact your gas dealer for the ignition to

be repaired.

11. Turn the adjustable knob in order to regulate the heat between HI and

LOW.

12. Ignite the right burner by repeating steps 6 to 10 with the right control

knob.

13. In order to switch off the barbecue, close the valve on the gas cylinder.

14. Following this, turn the adjustable knobs to the 12 o’clock position

(OFF).

Heat Distribution on the Barbecue Grille

As a result of the design of burner, the heat distribution is specied as

follows:

Barbecue cooking

Cooking

Keeping warm

Temperature Development in General

Due to the design, the highest temperatures always occur directly at

or above the burners and decrease accordingly towards the top. The

thermometer integrated in the lid can only measure the temperature in

the upper area of the cooking chamber due to its position and nature. The

temperatures displayed are therefore signicantly lower than the actual

temperatures at the burners or on the grill surface. The thermometer

therefore serves as a guide for your grilling process.

Tips for Barbecue Cooking

The gas barbecue is a multifunctional appliance. With the hood closed,

you can use your gas barbecue like an oven.

• You don’t have to only barbecue meat, sh, vegetables and fruit, you

can also cook them.

• With a closed hood, the temperature should not be allowed to get too

high. A low temperature results in gentle cooking of the barbecue food.

• Monitor the temperature on the thermometer and if necessary, adjust it.

ProfiCook PC-GG 1261 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info