587711
21
Zoom out
Zoom in
Vorherige Seite
1/28
Nächste Seite
Electrical connection
A protected mains supply cable is
to be connected to the outdoor
unit and 4-core control line is to
be connected to the indoor unit
respectively.
All electrical installation work
is to be performed by special-
ist companies. Disconnect the
voltage supply when connect-
ing the electrical terminals.
!
CAUTION
Make the connection as follows:
1. Open the air intake grill.
2. Unfasten the covers on the right
side (Figure 6).
3. Loosen the control line on the
terminal block and remove the
control cable.
Terminal strip
Control cable
Cover
Strain relief
Control cable
from the outdoor unit
6
Connecting the unit
Condensation pipe too large/small
Cannot freely drain away
MXD 200-520 IT
A 500 mm
16-20 mm
min. 2% fall
Condensation connection - Correct!
A
The unit's scope of delivery includes
a five metre long, four-core control
line for connecting the indoor unit
to the outdoor unit. The control line
to the outdoor unit contains a data
cable which makes communication
between the indoor unit and the
outdoor unit possible. This is used
for controlling cooling and heat-
ing output and for forwarding fault
indications to the indoor unit.
If the length is insufficient, you can
extend these control lines on the
indoor unit.
We recommend to install a main
/ repair switch on the building
near the indoor unit.
The terminal blocks for making
the connections are located at
the rear of the unit. When the
unit is installed, measurements
can be made from the front by
removing the cover.
If an optional condensation
pump is used in conjunction
with the unit, it may be neces-
sary to install an additional relay
with a higher contact rating
after the switch-off contact
on the pump to switch off the
compressor.
4. Connect the control line that has
been pre-prepared on-site to the
terminals (see electrical connec-
tion diagram P. 22).
5. Connect the on-site pre-prepared
control line with the supplied
control cable in a professional
manner.
6. Insert the control line plug into
the corresponding socket on the
outdoor unit.
7. Re-assemble the unit.
21
21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für REMKO MXD350 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von REMKO MXD350

REMKO MXD350 Bedienungsanleitung - Deutsch - 24 seiten

REMKO MXD350 Bedienungsanleitung - Holländisch - 24 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info