490426
12
Zoom out
Zoom in
Vorherige Seite
1/14
Nächste Seite
Page 9
TOT (Time-Out Timer)
TOT is the function that prevents from locking up a repeater or frequency by prolonged keying
of PTT. The time-out timer limits the amount of time you have to transmit your message. When
you reach the time limit which has been programmed by your dealer, your transmission will be cut
off. In order to transmit again, you must push PTT button to reset the timer.
BCLO (Busy Channel LockOut); BTLO (Busy Tone LockOut)
They are dealer programmable features as following:
Lockout type LCD show icon Lockout type LCD show icon
BCLO RBCLO , (ash)
BTLO
(ash), ,
RBTLO
,
BCLO: is to disable the Tx while receiving.
BTLO: is to disable Tx when receiving with same tone.
RBCLO : it wills be Tx while receiving (for repeater used).
RBTLO : it wills be Tx while receiving with same tone (for repeater used).
If the repeater is occupied by other group when you press PTT button, RBTLO will standby until
the using group is leaving. And then, the radio’s loudspeaker will beep for 3 times to remind you
that you are allowed to use the repeater now.
Busy Lockout On/OFF
Press button continuously until LCD show BCL-On( or BTL-On, RBTL-On, RBCL-On), press
or button to select On or OFF, press button to save the setting and get back to operation
menu or press again to gain access to other settings.
This function can be disable by your dealer.
Burst Tone
Burst tone is an alternative means of accessing the repeater, in addition to CTS or DCS tone.
1 1050Hz 5 1450Hz 9 1850Hz 13 2175Hz
2 1150Hz 6 1550Hz 10 1950Hz 14 2800Hz
3 1250Hz 7 1650Hz 11 2050Hz
4 1350Hz 8 1750Hz 12 2135Hz
Burst Tone On/OFF
Press button continuously until LCD show [BUTST-01], press or button to select burst
tone, press button to save the setting. To activate burst tone, you need to press button
when PTT button is pressed.
This function can be disable by your dealer.
Talk Around
This feature for you are out of the repeater range or repeater is not activated. you can directly
communicate with other radios in your group by using the talk around function. to set talk around.
press button continuously until LCD appear [TALKARUN ]. Press or button to select [AR-
TO-RV],[ AR-TO-TX] or [AR-TO-RX]. Press button to save setting.
12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Rexon RL-328S wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info