104114
5
Zoom out
Zoom in
Vorherige Seite
1/26
Nächste Seite
131
Appendix
Error Messages
If an error message is displayed on the LCD monitor or LCD panel, follow the
procedures below.
Error Message
System error occurs
Unable to change memory
Insufficient memory
Change to card
Format required
Format internal memory
Card is unavailable
Format error
UNMATCHED FILE
No file
Insufficient memory. Continue copy?
File number over. Cannot save.
Exceeded DPOF limit. Set up to 999.
Failed to create DPOF files
Failed to read DPOF files
Remedy
Turn the power off and on.
Storage memory can not be switched due to some reason. Check
content of storage memory or format storage memory.
Erase unwanted files or format to obtain sufficient memory space.
Change the storage memory to card by using .
Format of selected storage memory damaged. Format storage
memory.
Internal memory damaged. Format it by pressing shutter release
button.
Card damaged. Format.
Format again. If formatting is not completed, memory error
occurs. Avoid using the storage memory.
Unplayable file was selected.
No recorded files in specified folder. Change folder or select
storage memory that contains files.
Exceeded memory capacity. Perform one of following and copy
again:
Delete unnecessary copy source,
Delete unnecessary files in destination, or
Format storage memory.
File number exceeded limit. Delete unnecessary files or use
another memory card.
Number of index print or number of specified print exceeded limit.
Reset DPOF settings of some files.
DPOF settings cannot be saved. Delete unnecessary files before
repeating operation. If message still appears, memory may be
damaged. Make a backup file of files saved in memory and
format memory.
DPOF settings are unreadable. Reset all DPOF settings before
repeating operation. If message still appears, memory may be
damaged. Make a backup file of files saved in madia and format
memory.
Note
If the error message continues to be displayed after the above
procedures have been followed, open the terminal cover and press the
reset switch (P.6) with the tip of a propelling pencil or similar object.
The settings will return to the factory default settings.
If the error message is still displayed, contact the store where
purchased or your nearest Ricoh service office.
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Ricoh RDC-I 500 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Ricoh RDC-I 500

Ricoh RDC-I 500 Zusatzinformation - Englisch - 22 seiten

Ricoh RDC-I 500 Zusatzinformation - Englisch - 24 seiten

Ricoh RDC-I 500 Zusatzinformation - Englisch - 42 seiten

Ricoh RDC-I 500 Zusatzinformation - Englisch - 16 seiten

Ricoh RDC-I 500 Bedienungsanleitung - Englisch - 24 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info