167805
27
Zoom out
Zoom in
Vorherige Seite
1/32
Nächste Seite
27
5.1 SELECTING THE OPERATION MODE
The RODEK amplifiers feature an active crossover section with
full versatility and thus, offer different amplification modes,
which can be set by the operation mode slide switch(es). The
operation mode switch enables you to configure each stereo
channel pair to work in either fullrange, highpass or even band-
pass mode. Therefore - before you get started with the settings
of crossover frequencies and input gain adjustments - you
must select the appropriate operation mode for each channel
pair, depending on the speaker system that is connected and
driven by the amplifier. This will make sure that every speaker
system is only working in its proper frequency operation ran-
ge, for which the speaker was designed. For example select
HIGHPASS, if the speaker is a component- or coaxial type, or
BANDPASS in case of a kickbass or subwoofer system - and
finally FULL(range) if the passband frequency of the stereo
channel is already controlled by a head-unit with an integrated
DSP based active crossover.
5.3.1 HIGHPASS FOR COMPONENT AND
COAXIAL SPEAKERS
Before you start your adjustments, all tone controls (i.e. Bass,
Treble), fader/balance and the loudness function featured on
the head unit, must be set to their respective neutral or center
position.
Please take a look at the chart below, stating the recommended
high-pass cross-over frequency settings for coaxial- and compo-
nent speaker systems - and adjust the highpass control of each
channel pair that drives satellites speaker systems accordingly.
The most important factor for the individual adjustment of the
highpass cross-over frequency is the reproduction of mid-bass
frequencies and the resulting power-handling of the speaker
system. This setting is always a compromise. Try to find a high-
pass crossover frequency point, that will suit your personal
listening preferences and - at the same time - also considers the
physical (cone excursion) capabilities of your speakers best.
Satellite speaker system, front door mounted,
recommended highpass frequency
10 cm Coaxial- or Component System 90 - 120 Hz
13 cm Coaxial- or Component System 80 - 100 Hz
16 cm Coaxial- or Component System 60 - 90 Hz
Satellite speaker system, rear mounted, recommended
highpass frequency
10 cm Coaxial- or Component System 100 - 150 Hz
13 cm Coaxial- or Component System 120 - 150 Hz
16 cm Coaxial- or Component System 130 - 150 Hz
5. CROSSOVER SETTINGS
Ro 1-2-4-CH Manual_D+E def.indd 27 01.03.2006 10:55:38 Uhr
27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Rodek r 1900 n wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info