Bedienungsanleitung Seiko H851 (Seite 17 von 17) (Englisch)

757461

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

Troubles Possible causes Solutions Referen

The digital display

time and the

analog display

time are out of

sync.

The watch has been left close to an

object with a strong magnetic field or

it received a strong shock or

vibrations.

Set the standard hand position on

the analog display again. P. 26

The date changes

at 12 o’clock noon. AM/PM is not properly set. Set “Hour” for the time correctly. P. 23

Blur in the display

persists.

Small amount of water has got inside

the watch due to deterioration of the

gasket, etc.

Consult the retailer from whom the

watch was purchased. -

* For a solution to a problem other than listed above, contact the retailer from whom the watch was purchased.

EN 60

TROUBLESHOOTING

How to reset the system

If the watch does not work, the seconds hand does not return to one-second movement even if the battery

is sufficiently charged, or the watch operates irregularly, performing a system reset will return the watch to

normal.

1Unlock the crown.

* “Screw down crown” → P. 18

2Pull out the crown.

3Hold down Button A and Button B at the same

time for more than 10 seconds

• All hands will move to the 12 o’clock position, the digital

display will turn off, and the system will reset. When you let go

of the buttons, time and date setup will appear on the digital

display.

• The time and date will be shown as 1/1/2019, Tuesday,

12:00:00 am.

4Set the standard hand position and time/date.

• “How to set the time and date” → P. 23

• “How to set the standard hand position” → P. 26

EN 61

TROUBLESHOOTING

Specifications

Cal. H851

1.Features Three-hand (hour, minute, and seconds) analog display and digital display

2. Frequency of crystal

oscillator 32,768 Hz (Hz = Vibrations per second)

3. Loss/gain (daily rate) Monthly average loss/gain ± 15 seconds

Only if worn on the wrist in a temperature range of 5°C to 35°C.

4. Operational

temperature range −10°C to +60°C (the display function is 0°C to +50°C)

5. Driving system

(analog) Three step motors

6. Display (digital) FE (field effect) nematic liquid crystals

7. Power source Rechargeable battery: 1

8. Duration

Approx. six months (if the watch is not exposed to light after a full charge, the

stopwatch is used an hour a day, the light is used once a day (two seconds), the

alarm is used once a day (10 seconds), and power save mode is engaged for six

hours a day)

9. Light (digital) Internal light: LED

10. Electronic circuits Oscillation, division, drive: C-MOS LSI (1), LED circuit: C-MOS IC (1)

* The specifications are subject to change without prior notice due to product improvements.

EN 62

SPECIFICATIONS

Product : Combination Quartz Solar watch

Model : H851

This product is in compliance with the essential

requirements and other relevant provisions of

the RoHS Directive (2011/65/EU).

EN 63

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Seiko H851 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Seiko H851

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info