Bedienungsanleitung Skytech 3002 (Seite 4 von 10) (Englisch)

603162

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

INSTALLATION INSTRUCTIONS

The remote receiver can be Wall Mounted into a standard plastic switch box or (Hearth Mounted) placed on or near the

replace hearth. Determine where you will install the receiver before proceeding. Preferably, the remote receiver should

be wall-mounted in a plastic switch box, as this will protect its electronic components from both the heat produced by the

gas appliance and potential damage or abuse that can occur if it is left exposed on the hearth. PROTECTION FROM

EXTREME HEAT IS VERY IMPORTANT. Like any piece of electronic equipment the receiver should be kept away from

temperatures exceeding 130°F inside the receiver case. Battery life is also signicantly shortened if batteries are exposed

to high temperatures.

When installing the receiver into a switch box ensure the receiver switch is in the OFF position before installation. The

receiver is supplied with 18-inches of wire. If additional wire is required it is recommended that 18 gauge stranded or solid

wires (not included) be used to make connections between the terminal wiring block on the millivolt gas valve or electronic

module and the wire terminals on the remote receiver. For the best results, use 18 gauge stranded or solid wire, splice

into the black wires of the receiver or remove the black wires and install wires directly to the receiver. Be sure no splices

measure longer than 20-feet and allow ample wire to remove the receiver for annual battery replacement.

WALL MOUNTING

First, install (4) AA-size 1.5 ALKALINE batteries in the remote receiver (Fig 11). For best performance, remote receiver

batteries should be factory fresh when installed. The system operates best when battery output is greater than 5.3 volts.

Four (4) new AA batteries should provide an output voltage of 6.0 to 6.2 volts. Be sure batteries are installed with the

(+) and (-) ends facing the correct direction.

Next, attach wall mount cover plate to receiver box (Fig. 12):

Position the receiver as shown in the diagram to the left with lower tab on wall mount cover plate inserted into groove of

receiver. Move the receiver up and snap into top tab of cover plate.

Position the cover plate so the word ON is facing up (Fig. 13); then, install the remote receiver into the plastic switch box

using the two long screws provided. Push the slide button over the receiver slide switch only after making sure the remote

receiver has LEARNED the transmitter’s security code (see LEARNING TRANSMITTER TO RECEIVER).

Skytech: 3002

REV. 4-19-12 Page 4

Remote Receiver

Cover Plate

(Rear View)

Fig. 12. Wall plate to Receiver

Fig. 13. Installing receiver into switch box.

OFF

LEARN

ALL

Plastic Switch Box

Cover Plate

Receiver

Slide

Button

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Skytech 3002 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info