Bedienungsanleitung Solis 118 - Barista Perfect Pro (Seite 47 von 49) (Deutsch, Englisch, Französisch)

663497

Zoom out

Zoom in

Vorherige Seite

1/49

Nächste Seite

9392

NOTE: Please wipe off potential splashes of descaling solution on the outer housing

of the machine immediately, as the substance could damage the surface.

ATTENTION: Never submerge the power cord, plug or the machine in water

or any other liquid. While descaling the machine, never remove the water

tank or allow the tank to run completely empty.

s

TROUBLESHOOTING

Problem Possible Causes What to do

Coffee does not

run through

Machine is not turned

on or plugged in

Water tank is empty

The selection knob is

not in the „Espresso“

position

Coffee grind is too ﬁne

Too much coffee

in the ﬁlter

Coffee tamped too

ﬁrmly

The ﬁlter is blocked

Ensure the machine is plugged in and the

POWER button is ﬂashing or lightning.

Refer to “Filling the Water Tank”(page 74).

Turn the selection knob to the left, to the

„Espresso“ position .

Ensure you use a suitable espresso grind.

Ensure the correct amount (page 85).

Refer to “Tamping the Coffee Grounds with

the Tamper” (page 76).

Clean the ﬁlters. Refer to “Cleaning

the Filter Baskets, Portaﬁlter and Brewing

Group” (page 90).

Coffee runs out

too quickly

The coffee grind

is too coarse

Not enough coffee

grounds in the ﬁlter

Coffee grounds not

tamped ﬁrmly enough

Ensure you use a suitable espresso grind.

Ensure the correct amount of coffee grounds

(page 85).

See page 76, „Tamping the Coffee Grounds

with the Tamper“.

Coffee is too

cold

Cups not preheated

Milk not heated

enough (for Cappucci-

no or Caffè Latte)

Preheat cups. Refer to “Preheating all

Accessories” (page 83).

When the base of the jug becomes too hot

to touch this is when the milk is heated

at the correct temperature.

Refer to “Texturing Milk” (page 80).

s

DESCALING YOUR MACHINE

Hard water can lead to limestone deposits in and on many of the working parts

of the machine if it is used regularly. This reduces brewing ﬂow and power of the

machine and impairs the quality of the coffee. We therefore recommend regularly

(depending on water hardness, at least once every one to two months) descaling

the machine with a mixture of water and SOLIPOL

special.

Please follow the descaling instructions.

NOTE: We recommend using exclusively SOLIPOL

special as a descaling agent and

refuse to take any responsibility for damages caused by the use of other descaling

agents.

CAUTION: Should the descaling agent – even in a diluted form – splash or drip onto

the appliance, please wipe it off immediately to prevent damage to the surface of

the appliance.

Please descale as follows:

1. Check if the selection knob is set to the center standby position, the machine

is switched off with the POWER button (no light illuminating) and the power

plug is pulled.

2. Remove the portaﬁlter. Fill the water tank with the mixture of SOLIPOL

special

liquid descaling agent and water (SOLIPOL

special diluted with water at a 1:1

ratio).

3. Plug the power plug into the power outlet.

4. Press the POWER button so that the button surround

ﬂashes.

5. Place a large container under the brewing head and

the steam wand.

6. As soon as both button surrounds light up constantly,

turn the selection knob to the „Espresso“ position

and let half of the descaling solution run through the

brewing group.

7. Empty the container and place it back under the brewing head. Make sure that

the steam wand is pointing into the container. Turn the selection knob to the

„Steam“ position and let the remaining descaling solution escape through

the steam wand. Once no steam is passing out anymore, return the selection

knob to the center, to the standby position.

8. When the descaling solution is almost used up, remove the water container and

carefully rinse it with fresh water to remove all descaling agent residues. Reﬁll

it with fresh tap water.

9. To rinse the machine as well and to remove all descaling agent residues, please

repeat steps 3 to 7 until only a little water remains in the water tank. Pour this

last bit of water away and reﬁll the tank with fresh tap water. Your appliance is

now ready for use again.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Solis 118 - Barista Perfect Pro Seite 47

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Solis 118 - Barista Perfect Pro

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info