Bedienungsanleitung Solis 118 - Barista Perfect Pro (Seite 45 von 49) (Deutsch, Englisch, Französisch)

663497

Zoom out

Zoom in

Vorherige Seite

1/49

Nächste Seite

8988

■ RUNNING THE CLEANING CYCLE

Through regular use, residues of coffee powder and coffee oil form in the appliance,

impairing the brewing process. Therefore, you should perform a cleaning cycle once

every 2 to 3 months.

SOLITABS

20 SECONDS

➊ ➋ ➌ ➍ ➎ ➏

Please proceed as follows:

– Empty the drip tray and ﬁll the water tank.

1. Place the rubber disk in the ﬁlter insert (for one or two cups) and the ﬁlter insert

in the portaﬁlter.

2. Place a SOLITABS cleaning tablet (without sponge) in the ﬁlter insert, on the

rubber disk.

3. Twist and install the portaﬁlter in the brewing head.

4. Switch the machine on by pressing the POWER button. Wait for the control light

in the button surround lights up constantly.

5. Turn the selection knob to the „Espresso“ position for 20 seconds. Return

the selection knob to the standby position in the center. Repeat both steps until

the cleaning tablet has completely dissolved.

6. Switch the appliance off with the POWER button, remove the portaﬁlter and

check if the SOLITABS tablet has completely dissolved. Should this not be the

case, repeat steps 3 to 5 until the tablet has completely dissolved. Should the

SOLITABS tablet have dissolved, rinse the portaﬁlter and the ﬁlter basket with

warm water.

– Should you encounter problems when making espresso the next time, please refer

to the section „Troubleshooting“ for ideas on how to solve the problem.

– The Troubleshooting section can be found on page 93–95.

– SOLITABS cleaning tablets are available from good specialist retailers or from

Solis of Switzerland Ltd.

Telephone: 0848 804 884, Telefax: 0848 804 890

email: info.ch@solis.com or www.solis.ch

(Shipping only within Switzerland)

■ CLEANING THE STEAM WAND

each usefrom wand after texturing

➊ ➋ ➌ ➍ ➎

The steam wand must always be cleaned each time after texturing milk.

Proceed as follows:

1. Point the steam wand towards the drip tray and turn the selection knob to the

„Steam“ position . By doing this, you remove potential milk residue in the

steam wand by letting some steam run through.

Return the selection knob to the center, to the standby position. Switch the

machine off with the POWER button and let the appliance cool down.

2. Wipe the outside of the steam wand with a damp cloth.

3. If the steam wand remains blocked, use the pin on the cleaning tool to clear

the opening.

4. If the steam wand remains blocked at all, the tip of the steam wand can be re-

moved by using the spanner in the centre of the cleaning tool. Unscrew the tip.

5. Soak the tip in hot water before using the pin on the cleaning tool to unblock.

Replace the tip back onto the steam wand and secure with the spanner in the

cleaning tool.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Solis 118 - Barista Perfect Pro Seite 45

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Solis 118 - Barista Perfect Pro

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info