680562
27
Zoom out
Zoom in
Vorherige Seite
1/30
Nächste Seite
Maintenance and care
t
– 27
Regular testing
Regularly check that the safety devices function correctly; no less than every six months. See EN 12453:2000.
Check that pressure-sensitive safety devices (e.g. safety contact strip with extra evaluation unit) are operating correctly every four weeks
(see EN 60335-2-95).
In particular, check whether the drive reverses correctly when it encounters a 50 mm high obstacle lying on the ground. Correctly adjust if necessary and
recheck; an incorrect setting presents a hazard.
Testing Behavior yes/no Possible cause Remedy
Force cut-off
Try to stop the door wing
while it is closing with
a 50 mm high object.
Does the drive reverse when
it encounters the object?
yes The force cut-off works
without limitations.
Leave all settings as they are.
no Door incorrectly adjusted. Adjust door, call a technician.
Emergency release
Proceed as described in the
chapter “Operation/use -
emergency release”.
The emergency release can
be easily actuated (pull once
and the drive releases).
yes Everything is OK.
no Drive forces the door
closed.
Door and drive
mechanism is stressed.
Emergency release
defective.
Door jams.
Adjust door CLOSE end switch or switch on
Backjump (DIP switch 6 ON).
Repair emergency release.
Check door, see door owner's manual.
Safety contact strip,
if present.
Open and close the door
and actuate the strip at the
same time.
Adjust the behavior of the
door, as set with DIP switch
1, 2 or 3.
yes Everything is OK.
no Cable breakage, terminal
loose.
DIP switch adjusted.
Strip defective.
Check the wiring; retighten the terminals.
Setting the DIP switches.
Decommission the system and lock it to
prevent reactivation. Then, contact customer
service.
Photo eye, if present
Open and close the door
while interrupting the photo
eye.
Adjust the behavior of the
door, as set with DIP switch
1, 2 or 3.
yes Everything is OK.
no Cable breakage, terminal
loose.
DIP switch adjusted.
Photo eye dirty.
Photo eye misadjusted
(holder bent).
Photo eye defective.
Check the wiring; retighten the terminals.
Setting the DIP switches.
Clean the photo eyes.
Adjust photo eyes.
Decommission the system and lock it to
prevent reactivation. Then, contact customer
service.
27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

sommer-duo-vision-650

Suche zurücksetzen

  • Wie kann ich beim Tor schließen das unnötige Stoppen und Reversieren ausschalten, wenn es keine Lichtschranke, Hindernisse und Widerstände gibt? Eingereicht am 18-4-2024 22:19

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sommer Duo vision 650 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Sommer Duo vision 650

Sommer Duo vision 650 Bedienungsanleitung und Installationsanweisung - Deutsch - 30 seiten

Sommer Duo vision 650 Bedienungsanleitung und Installationsanweisung - Holländisch - 30 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info