Bedienungsanleitung Synq SMX-1 (Seite 4 von 43) (Deutsch, Englisch, Holländisch, Französisch, Portugiesisch, Spanisch)

468139

Zoom out

Zoom in

Vorherige Seite

1/43

Nächste Seite

ENGLISH USER MANUAL

SYNQ 3/82 SMX-1 DJ-MIxer

 When the power switch is in OFF position, this unit is not completely disconnected from

the mains!

 This appliance must be earthed to in order comply with safety regulations.

 In order to prevent electric shock, do not open the cover. Apart from the mains fuse there

are no user serviceable parts inside.



Never

repair a fuse or bypass the fuse holder.

Always

replace a damaged fuse with a

fuse of the same type and electrical specifications!

 In the event of serious operating problems, stop using the appliance and contact your

dealer immediately.

 Please use the original packing when the device is to be transported.

 Due to safety reasons it is prohibited to make unauthorized modifications to the unit.

INSTALLATION GUIDELINES:

 Install the unit in a well-ventilated location where it will not be exposed to high

temperatures or humidity.

 Placing and using the unit for long periods near heat-generating sources such as

amplifiers, spotlights, etc. will affect its performance and may even damage the unit.

 The unit can be mounted in 19-inch racks. Attach the unit using the 4 screw holes on

the front panel. Be sure to use screws of the appropriate size. (screws not provided)

Take care to minimize shocks and vibrations during transport.

 When installed in a booth or flight case, please make sure to have good ventilation to

improve heat evacuation of the unit.

 To avoid condensation to be formed inside, allow the unit to adapt to the surrounding

temperatures when bringing it into a warm room after transport. Condense sometimes

prevents the unit from working at full performance.

CLEANING THE MIXER:

Clean by wiping with a polished cloth slightly dipped with water. Avoid getting water inside

the unit. Do not use volatile liquids such as benzene or thinner which will damage the unit.

ENGLISH USER MANUAL

SYNQ 4/82 SMX-1 DJ-MIxer

CONTROLS AND FUNCTIONS

CONTROLS ON THE BACK:

1. MAINS INPUT: Use the supplied mains cable to connect this input to the mains.

2. MASTER1 BALANCED OUTPUT: The XLR-connectors can be used to connect the

SMX-1 to the PA, using special balanced signal cables.

3. TRIM OUTPUT: This potentiometer is used to reduce the output level of the mixer

to protect the connected amplifiers and speaker cabinets. (Attention: the output

level can be reduced to zero. If you don’t have any signal on the master output, first

check if this potentiometer is accidentally put to zero.)

4. DIGITAL OUTPUT: This digital output makes it possible to make digital recordings

on any connected digital recorder. The output is not affected by the master fader.

5. FADER CONTROL: When connected to these inputs, compatible CD-players can

be controlled by the fader starts and cross fader effects of the SMX-1.

6. MASTER1 UNBALANCED OUTPUT: The same output signal as on the balanced

master output(2) but unbalanced. Can be used to connect unbalanced amplifiers.

7. ZONE OUTPUT: Also called master2 with separate level control, used to connect

extra amplifiers.

8. RECORD OUTPUT: Carries the same signal as the master outputs but is not

influenced by the master level, balance and mono/stereo controls. Used to connect

analog recording equipment.

9. LINE INPUT: Used to connect any line level unit you have (CD, tuner, MD, …)

10.PHONO/AUX INPUT: Normally used to connect a turntable but, when you put the

“phono/aux” switch(11) in the right position, you can also connect any line level unit.

11.PHONE/AUX SWITCH: Used to choose the input level of the “phono/aux input”(10).

12.GROUND (GND) CONNECTION: Many Turntables have a GND-connection. It is

preferable to connect this signal ground to the GND-connector.

13.MIC 2&3 INPUTS: Used to connect 2 extra unbalanced microphones.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Synq SMX-1 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info