540638
2
Zoom out
Zoom in
Vorherige Seite
1/3
Nächste Seite
Tacx Trainer software Connected devices
- 2 - October 17, 2013
No connection
If there is no connection, the device is displayed with a red cross. Make
sure the USB cable is properly connected and the adaptor switch is on.
If the connection does not work, it may be that the driver is not installed
properly. Go to the Tacx website and check the Frequently Asked
Questions about problems with the USB connection and the installation
of the driver.
Linking Bushido/Vortex
When starting up the Tacx Trainer software, the software automatically
searches for the Bushido and Vortex ergotrainer, if the ANT+ stick is in
the computer. It is also possible, using the menu at the right, to
manually link the connected devices to the PC. Make sure that the
ANT+ USB stick is plugged firmly into the computer and that there are
no interfering obstacles.
Linking Genius
First use
Read the instructions on the screen and follow the steps below:
1. Plug the ANT+ stick into the computer.
2. Start up the software. When a pop-up appears, push the middle button of the interface
computer simultaneously (as shown).
3. A pop-up appears with the message that the new interface computer has been found.
Confirm with Connect.
4. Run the keypad calibration by pushing the upper arrow.
5. Make sure that the wheel has been placed correctly on the brake.
6. A pop-up appears with the message that the new brake has been found. Confirm with
Connect.
BlackTrack
1. It will connect automatically when the batteries have been put in the BlackTrack and by
steering to the left.
2. A pop-up appears with the message that the new BlackTrack has been found. Confirm with
Connect.
When you have used the trainer before, the software will find the trainer automatically the next time,
after you have plugged the brake into the power grid and after pressing on the interface computer.
When the BlackTrack is in sleeping mode, you have to turn the wheel to the left as far as possible. A
green light will then start to blink.
2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Tacx Tacx Trainer software 4 Trainingen wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Tacx Tacx Trainer software 4 Trainingen

Tacx Tacx Trainer software 4 Trainingen Bedienungsanleitung - Englisch - 10 seiten

Tacx Tacx Trainer software 4 Trainingen Bedienungsanleitung - Holländisch - 11 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info