Bedienungsanleitung TFA 35.1045.IT - Laluna Funk (Seite 14 von 16) (Englisch)

466142

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

BACK-LIGHT

The back-light is automatically switched ON when any keys are pressed. The back-light will

be switched on for approximately 8 seconds before automatically switching OFF.

ABOUT THE OUTDOOR TRANSMITTER

The range of the Thermo-hygro transmitter may be affected by the temperature. At cold

temperatures the transmitting distance may be decreased. Please bear this in mind when

positioning the transmitters. Also the batteries may be reduced in power for the Thermo-

hygro transmitter.

CHECKING FOR 868MHz RECEPTION

If the outdoor temperature and humidity data are not being received within three minutes

after setting up (or outdoor display always show “- -. -” in the outdoor section of the weather

station during normal operation), please check the following points:

1. The distance of the Weather station or transmitters should be at least 2 meters away

from any interfering sources such as computer monitors or TV sets.

2. Avoid placing the transmitters onto or in the immediate proximity of metal window

frames.

3. Using other electrical products such as headphones or speakers operating on the

868MHz-signal frequency may prevent correct signal transmission or reception.

Neighbors using electrical devices operating on the 868MHz-signal frequency can also

cause interference.

Note:

When the 868MHz signal is received correctly, do not re-open the battery cover of either the

transmitter or Weather station, as the batteries may spring free from the contacts and force a

false reset. Should this happen accidentally then reset all units (see “Setting up” above)

otherwise transmission problems may occur.

The transmission range is around 100 meters from the Thermo-hygro transmitter to the

Weather station (in open space). However, this depends on the surrounding environment

and interference levels. If no reception is possible despite the observation of these factors,

all system units have to be reset (see “Setting up” above).

POSITIONING THE WEATHER STATION

The weather station provides the option of table standing or wall mounting the unit. Before

wall mounting, please check that the outdoor data can be received from the desired

locations.

To wall mount:

1. Fix a screw (not supplied) into the desired wall, leaving the head

extended out by about 5mm.

2. Place the weather station onto the screw, using the hanging hole on

the backside. Gently pull the weather station down to lock the screw

into place.

Foldout table stand:

The foldout table stand leg is located on the backside. Pull the stand out

from the bottom center edge of the weather station, below the battery

compartment. Once the foldout table stand is extended, place the weather

station in an appropriate location.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

TFA 35.1045.IT - Laluna Funk Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von TFA 35.1045.IT - Laluna Funk

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info