Bedienungsanleitung Triton T12ID (Seite 6 von 50) (Deutsch, Englisch, Holländisch, Französisch, Spanisch)

665019

Zoom out

Zoom in

Vorherige Seite

1/50

Nächste Seite

PREPARATION

Unpacking Your Tool

Carefully unpack and inspect your tool. Familiarise yourself

with all its features and functions.

Ensure that all parts of the tool are present and in good

condition. If any parts are missing or damaged, have such

parts replaced before attempting to use this tool.

Before Use

• This impact driver has been shipped in a low charge

condition. Charge the battery before use

Battery charger operation

• The charger and battery may become warm while

charging. This is normal and does not indicate a

problem

• Use the charger at normal room temperatures

whenever possible. To prevent overheating, do not

cover the charger and do not charge the battery in

direct sunlight or near sources of heat

If the battery does not charge properly:

• Check current at power outlet by plugging in a lamp or

other appliance

• If charging problems persist, have the impact driver,

battery and battery charger checked by an electrician

or a power tool technician

Charging the battery

1. Depress the Battery Release Grips (4) and remove the

battery from the tool

2. Insert the battery into the Battery Charger (8). Do not

use excessive force when inserting the battery. If it

does not slide into place easily, it is not being inserted

correctly

3. Initially only the green LED may ﬂash as it evaluates the

status of the battery. When charging the red LED will

illuminate and the green LED will be OFF

4. When the battery is fully charged the red LED will be

OFF and the green LED will illuminate

5. The battery charger will constantly monitor the

condition of the battery when charging

6. Remove the battery as soon as possible when

completely charged

7. Disconnect the charger from the power supply and

store in a clean, dry environment out of the reach of

children

• Normal battery charging time is approximately 1hr for a

recently fully discharged battery at normal temperature.

Charging times will vary outside these conditions

• You do not need to fully discharge the battery before

recharging but you should not attempt to recharge a

battery that is already fully charged

• You can interrupt charging at any point to use the

battery. Under normal conditions the charger charges

at a higher rate but reduces the charging rate as the

battery becomes fully charged. An 80% charge is

achieved after 1/2hr of charging.

3.0Ah High Capacity Battery (optional accessory)

• A high capacity battery is available that provides double

the capacity. It also allows the drill driver to stand

vertically which may be advantageous for some uses.

Please note the full charging time will be approximately

120 minutes for the high capacity battery.

Battery Charging Table

NOTE: If the lights on the battery charger fail to illuminate

according to the chart above or indicate a fault condition:

• Check the battery is ﬁrmly seated in the battery charger

• Check all connections and that mains power is

switched on

Initial charge

• The initial charge will vary depending on the existing

charge in the battery. Allow the battery to reach full

charge as indicated on the charger

• After discharging, recharge the battery completely, as

indicated by the LED on the battery charger, for the

next 4 to 5 uses. This will ensure that the battery is

performing to its highest capacity

• Subsequent full charges will take approximately 1 hour,

however the battery can be recharged when the battery

is only partially discharged

Red LED Green LED

Charger plugged In OFF Flashing

Charger evaluating battery OFF Flashing

Fast charging ON Off

Highly discharged battery

slow charging

Flashing Off

Abnormal battery

temperature charging

Flashing Off

Fully Charged OFF On

Battery or charger fault Flashing Flashing

Temporary abnormal

temperature condition

On On

725488_Z1MANPRO1_15/04/14.indd 6 18/09/2015 15:11

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Triton T12ID Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info