Bedienungsanleitung Vortex Viper Riflescope (Seite 3 von 4) (Englisch)

540499

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

Final sight-in should be done at the range using the exact

ammunition you expect to hunt or shoot with. For Viper PA

riflescopes, set the parallax adjustment to match the distance

used for sight-in.

6. The Final Range Sight-In

A. After the scope has been bore-sighted, fire a shot or two

to check that you’re roughly on target. If necessary, adjust

the reticle to put you near the center of the target (see page 7).

B. Next, fire a three-shot group as precisely as possible. Use the

center of this group as a reference when making any necessary

correction adjustments for windage and elevation. Adjust the

dials in the direction you wish the group to move.

C. Fire a final three-shot group to confirm your adjustment and

repeat as necessary.

Viper riflescopes feature windage/elevation dials that will allow you to

re-index the zero indicator after sight-

in without disturbing your settings.

This allows you to quickly return

to your original zero if temporary

corrections are used in the field. Reset

the windage and elevation dials in

this way:

7. Resetting Adjustment Dials with Zero Reset

A. Remove the outer cap and

pull the adjustment dial outward

against the spring tension until it stops.

B. With the dial pulled fully outwards, rotate the dial to reposition the

zero mark on the index line.

C. Release the dial, allowing it to return to the normal inward position.

Riflescope Installation Continued

Riflescope Maintenance

Your Viper riflescope will require very little routine maintenance other than periodically cleaning the exterior lenses. All components of Vortex

riflescopes are permanently lubricated so no additional lubricant should be applied.

Do not attempt to disassemble any components of your riﬂ escope. Avoid storage

in direct sunlight or hot locations since high temperatures can adversely affect

internal lubricants.

When cleaning the lenses, be sure to use products such as the

Vortex Lens Pen or the Fog Free lens cleaning kits that are

designed for use on coated optical lenses. Be sure to blow away

any dust or grit on the lenses prior to wiping the surfaces. Using

your breath, a very small amount of water, or pure alcohol can

help remove oil and dried water spots.

Lens Care

Clean the exterior of the riflescope by wiping with the soft, dry

cleaning cloth provided with the Viper riflescope.

Riflescope Body Care

Riflescope Troubleshooting

Please check the following before returning a riflescope for service.

Many times, problems thought to be with the riﬂ escope are actually with the

riﬂ escope’s mount.

1. Be sure the mounts are tight to the rifle and that the scope is

secure in the rings; you should not be able to twist or move

the scope in the rings.

2. Insufficient windage or elevation adjustment range can

indicate alignment problems with base mount holes drilled in

the rifle’s receiver or riflescope base; this may also indicate

alignment problems with barrel and receiver. Re-center the reticle

(see page 10) and then check the bore sight. If the reticle is way

off while centered, base adjustment or shimming may be needed.

Consult a qualified gunsmith if unsure of correct procedure.

3. If a rifle fails to group well, be sure the rifle’s action is bedded

correctly and that all mounting screws are properly tightened.

The rifle’s barrel and action must be clean and free of excessive

oil or copper fouling. Be sure the ammunition works well with

the rifle—try a type known to have grouped well in the rifle.

www.vortexoptics.com

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Vortex Viper Riflescope Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info