Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
www.AKTOBIS.de
Email: Info@Aktobis.de
3. Timer operation
This is the recommended operating mode. Use the stepless control dial to select an operating time between0 - 90
minutes (see description of the control panel).
The timer operation works on the basis of an "egg timer" and after the set operating time has elapsed, the ozone
production switches off automatically.
During ozone operation/production, the red signal light is on (see description of the control panel).
4. Continuous operation
In this operating mode, the ozone production no longer switches off automatically and runs permanently. This
operating mode is only recommended if you want an ozone treatment time of more than 90 minutes or if the user
wants to monitor the operating room/object with ozone protective equipment (face mask).
To switch on the ozone continuous operation, you must also switch the small round continuous operation switch to
ON (see description of the control panel).
During ozone operation/production, the red signal light is on (see description of the control panel).
5. Recommendations for the duration of treatment
The treatment time depends on factors such as room temperature, room size, inventory type, object type, load
intensity and air circulation.
We recommend a room temperature between 20°C - 25°C and a humidity of less than 65 % relative humidity. If
people or animals are present in the room shortly after the ozone treatment, the room temperature should be
slightly lower after the treatment than during the treatment to ensure that ozone does not form again due to natural
reactions.
Except for large rooms, a desired high depth of effect and very aggressive odours (e.g. fire smell, butyric acid), a
treatment time of maximum 6 hours should be sufficient. If the problem is not eliminated after this time, it is more
advisable to repeat the treatment than to run the risk of too high ozone concentrations.
Below are a few non-binding guideline values for the treatment duration at full ozone output level
(5 g/h). Unless otherwise stated, these values apply to a room size of up to approx. 30 m² (75 m³):
Category I odours
(tobacco odours, animal odours, food odours, waste odours, etc.)
Between 30 and 90 minutes
Category II odours
(Burning odours, musty odours, toilet odours, acid odours and chemical odours such as paints, varnishes, solvents,
etc.).
Between 90 and 800 minutes
Mould remediation
Between 90 and 800 minutes
Disinfection:
Between 30 and 80 minutes
Automotive treatment:
Between 30 and 80 minutes
