Bedienungsanleitung XtremeMac Luna (Seite 10 von 13) (Englisch)

496940

Zoom out

Zoom in

Vorherige Seite

1/13

Nächste Seite

LUNA™ User Manual

Charging your iPod:

Luna will charge dock connector iPod models (4G models and later).

Make sure that your iPod is properly docked in the system. Once properly

docked, Luna will charge your iPod.

Setting the Sleep Mode Preferences

Setting the Sleep Timer:

1. Select the desired audio source (see “Listening to Audio” on pages 16-

17).

2. Push the Right Control Knob to access the main menu. The menu will

appear on Luna’s display.

3. Turn the Right Control Knob until the “Sleep” item is highlighted and

push to select.

4. Push the Right Control Knob again to turn sleep timer on.

5. Turn the Right Control Knob until the “Duration” menu item is highlighted

and push to select. The sleep time will blink to indicate that it can be

adjusted. Turn the Right Control Knob to increase/decrease the sleep

time (from 1 to 90 minutes) and push to accept.

Setting Sleep Options

– While in the sleep menu, turn the Right Control Knob until the

“Decrease Volume” menu item is highlighted and push to select

“On” or “Off”. Activating this feature will decrease the volume

gradually over the sleep time.

– While in the sleep menu, turn the Right Control Knob until the

“Dimmer” menu item is highlighted and push to select. The

dimmer level will blink to indicate it can be adjusted. Turn the Right

Control Knob to increase/decrease the dimmer level (from 0 to 20)

and push to accept.

SHORTCUT

You may also enter the sleep mode by holding the

Right Control Knob while audio is playing. The sleep

time will appear in the top line of the display.

Turn the Right Control Knob at any time to increase/

decrease the sleep time.

Restoring Default Settings

Using this operation will reset all of your programmed settings back to

factory default settings (except contrast).

1. Push the Right Control Knob to access the main menu. The menu will

appear on Luna’s display.

2. Turn the Right Control Knob until the “Settings” menu item is highlighted

and push to select.

3. Turn the Right Control Knob until the “Reset Settings” menu item is

highlighted and push to select.

4. Push the Right Control Knob again to conﬁrm reset.

Replacing the Remote Battery

The remote control battery is already installed at the factory. Before using,

make sure to pull out the “Remove” tab that is protecting the battery. When

the remote control stops operating or its range seems reduced, it is time to

replace the battery.

To Replace the Battery:

1. The battery door is located on the bottom of the remote control. To open,

hold the remote with the back facing up and squeeze the latch while

pulling out the battery door.

2. Take out current battery and replace with a “CR2025” 3-volt Lithium Cell

battery. The battery door has a “+” symbol to indicate correct placement.

Place the battery with the “+” side of the battery on the same side as this

symbol.

3. Replace the battery door with the “+” of the battery facing up.

Note: Please dispose of batteries properly.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

XtremeMac Luna Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info