674740
61
Zoom out
Zoom in
Vorherige Seite
1/154
Nächste Seite
Page 59
FT-991 OperaTing Manual
1. Press the
BAND
button to show the band list, and
then touch a band key corresponding to the Amateur
band on which you wish to operate. Press the
BAND
button again, to close the band list screen.
2. Press the
MODE
button to show the mode list, and
then select the operating mode by touching the cor-
responding key. Press the
MODE
button again, to
close the mode list screen.
Advice:
By convention, LSB is used in the 7 MHz and lower
Amateur bands for SSB communication, and USB is
used on the 14 MHz and higher bands (the 10 MHz
band is used for CW and data modes only).
3. Rotate the Main Tuning Dial knob to adjust the op-
erating frequency. Alternately, you may use the
UP
/
DWN
scanning buttons on the
MH-31
A8J
Hand Mi-
crophone to scan up or down the current band.
4. Press the microphone
PTT
(Push To Talk) switch to
begin transmitting; speak into the microphone in a
normal voice level.
Advice:
The “
” indicator will light up in the TFT LED
indicators area, conrming that transmission is in
progress.
When transmitting in the AM mode, set a maxi-
mum (carrier) power output of 25 Watts by press-
ing
[
RF PWR
]
, then rotate the
MULTI
knob.
5. Adjust the microphone amplier gain to match the
microphone and your voice level: Touch
[
METER
]
on the LCD repeatedly to select the “
ALC
”.
Press and hold the
PTT
switch, and speak into the
microphone in a normal voice level.
In the SSB mode, touch
[
MIC GAIN
]
and then ad-
just
MULTI
knob so that the ALC meter stays within
the ALC zone of the meter (up to half scale deec-
tion) on voice peaks.
ssb/aM MoDe transMission
ON/OFF Switch
Main Tuning Dial Knob
F(M-LIST) Button
MULTI KnobMODE Button
BAND Button
In the AM mode, touch
[
MIC GAIN
]
and then adjust
the
MULTI
knob so that the ALC meter does not de-
ect on voice peaks.
When transmitting In the AM mode, adjust the
MIC gain so that the PO meter does not deect
when speaking.
6. Release the
PTT
switch at the end of the transmis-
sion. The transceiver will return to the receive mode.
61

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yaesu FT-991 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info