Controls and Functions
(1) MIC IN connector
A microphone with an impedance of about 600 ohms can
be connected here, for use as an additional input source.
Either an XLR plug (balanced connection) or a phone
plug (balanced/unbalanced connection) can be used.
Normally the input signal from this connector is mixed
with the signal from the rear-panel INPUT jacks. When
the VOCODER effect is selected, the signal from this
connector serves for controlling the sound character and
the envelope (volume change curve) of the VOCODER
effect.
(2) MIC ON/OFF switch
This switch turns the signal from the MIC IN connector
on and off. When the switch is ON, the indicator at the
right lights up.
(3) INPUT control
Serves to adjust the signal from the INPUT jacks and the
MIC IN jack.
(4) OUTPUT control
Serves to adjust the level of the signal supplied at the
OUTPUT jacks.
(5) MIX control and LED
Serves to adjust the balance between original sound
(DRY) and effect sound (WET). When the control is
turned fully counterclockwise, only the original sound is
output. When the control is turned fully clockwise, only
the effect sound is output. If the mixing balance setting
was changed since the last store operation, the LED lights
up.
(6) CANCEL key
Serves to cancel a store operation.
(7) COMPARE key
When a patch (group of stored effect settings) is being
edited, this key can be used to compare the sound before
and after the edit.
(8) MIDI key
This key is used to make various MIDI settings.
(9) PARM CHECK key
Serves for checking effect parameter settings.
(10) STORE key
Used for storing patches in memory and other functions.
Front Panel
Rear Panel
(1) POWER connector
The supplied power cord is to be connected here for
powering the unit.
(2) MIDI connectors
Serve for connection to the MIDI interface of a computer
or to a MIDI keyboard or similar. This allows patch
switching from external equipment.
(3) BYPASS jack
Serves for connection of the foot switch FS01 (option) for
switching effects on and off.
(4) DIGITAL OUT connectors
The same signal as available at the OUTPUT jacks is
carried by these connectors in S/PDIF digital format. This
can be used to supply the signal to consumer equipment
Controls and Functions
2
ZOOM RFX-2200
