Bedienungsanleitung Acec ab 256 (Seite 7 von 14) (Englisch)

330486

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

Replacing the Oven Light

 Ensure the electricity supply is switched off before

carrying out this operation.

The oven bulb has to comply to these features:

a) resistant to temperatures of 300 °C;

b) electric rate: 230 V - 50 Hz;

c) electric power rate: 15 W.;

d) connection type: E 14.

To replace the bulb, proceed as follows (Fig. 8):

a) push in and turn the glass lid anticlockwise;

b) remove tha faulty bulb;

c) replace it with a new one;

d) refit the glass lid;

e) switch on the electricity supply.

General Cleaning

 Before cleaning, always allow the oven to cool down.

 When using spray cleaning products, be careful not

to spread them on the heating elements or on the

thermostat sensor.

 Never use harsh abrasives, steel wool or cleaners

with bleach, as they could damage the enamel and

the oven door glass.

The Oven Cavity

The enamelled oven cavity is best cleaned whilst the oven

is still warm. It is advisable to wipe the oven over with a soft

cloth soaked in warm soapy water after each use.

However, from time to time, it will be necessary to do a

more complete cleaning, using a proper oven cleaner.

In case of particularly tough stains, you can use stainless

steel cleaning products or some warm vinegar.

 If cooking fruits, some over-heated natual acids can

squeeze and settle on the oven enamel, causing stains

quite difficult to remove. This could affect the enamel

brightness, but it will have no consequence on the oven

performances. To avoid these stains to be burnt out during

the next cooking, carefully clean the oven cavity after all

fruits cookings.

The Oven Door and its gasket

Before cleaning the oven door, we recommend you to

remove it from the oven.

Proceed as follows:

a) open the oven door completely;

b) find the hinges linking the door to the oven (fig 6);

c) unlock and turn the small levers located on the

two hinges (fig. 6);

d) handle the door by its left- and right-hand sides,

then slowly turn it towards the oven until it is half-

closed;

e) gently pull the oven door off its site (fig. 6);

f) place it on a steady plan;

g) unscrew the two screws marked with lett. A

fig.7;

h) pull up the oven door glass and take it away from

the oven door.

Clean the oven door glass with warm water and a softh

cloth only.

Once the cleaning is carried out, refit the oven door,

following the procedure in reverse.

The correct operation of the oven is ensured by a gasket

placed round the edge of the oven cavity.

 Periodically check the condition of this gasket. If

necessary, clean it without using abrasive cleaning

products.



If the gasket shows to be damaged, call you local

Service Centre. Do not use the oven until it has been

repaired.

Fig. 8

FO 0287

Fig. 6

Fig. 7

FO 0288

FO 0027

Cleaning and Maintenance

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Acec ab 256 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Acec ab 256

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info