638708
4
Zoom out
Zoom in
Vorherige Seite
1/9
Nächste Seite
TEMPERATURE SENSOR SELECTOR
Under normal conditions the room temperature
is detected and checked by the temperature
sensor placed in the air conditioner.
Press the remote control I FEEL button to
activate the temperature sensor placed in
the remote control. This function is designed
to provide a personalised environment by
transmitting the temperature control command
from the location next to you. Therefore, in
using this function, the remote control should
always be aimed, without obstruction, at the air
conditioner.
OPERATION WITH THE REMOTE CONTROL UNIT
Check that the circuit breaker on the power
panel is turned ON and the STANDBY lamp is
light up.
When using the remote control unit, always
point the unit transmitter head directly at the air
conditioner receiver.
HOW TO TURN ON THE AIR CONDITIONER
Press the ON/OFF button to turn the air
conditioner on. The indicator OPERATION will
light up, indicating the unit is in operation.
NOTE
The remote control unit sends the temperature signal to the air morf
langis eht fI .slavretni etunim owt ta ylraluger renoitidnoche remote
control unit stops for more than ve minutes due to some troubles,
the air conditioner will switch to the temperature ensor which is built
into the indoor unit and controls the room temperature. In these cases,
the temperature around the remotecontrol unit may differ from the
temperature detected in the air conditioner position.
REMOTE CONTROL
UNIT DISPLAY
USING THE REMOTE CONTROL UNIT
USING THE REMOTE CONTROL UNIT
HOW TO INSTALL BATTERIES
Remove the lid in the rear part of the remote
control unit.
Insert two AAA alkaline batteries of 1,5 V-DC.
Make sure to insert the batteries according to the
polarity(+/-)
marked in the battery compartment.
Push the lid back on.
Remove the lid in the rear part.
Press the battery toward the negative end
and lift it out by its positive end as shown.
General Note:
Remove the other battery in the same way.
HOW TO REMOVE BATTERIES
Replace the batteries when the remote control unit lamp fails to light, or when the air conditioner does not receive the
remote control unit signals.
Remove the batteries if you do not use the remote control unit for more than one month.
The batteries last about six months, depending on how much you use the remote control unit.
The batteries of the remote control contain polluted substances exhausted batteries must be disposed according to the
laws in force.
After batteries change:
Press the +,-, SET and CLEAR buttons together.
( After batteries change the remote control needs to be
reset to ensure proper functioning. By pressing above
mentioned buttons, remote control programs are reset.)
The button+, - refered to above is the buttons for
setting the hour not
temperature.
3
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Airwell RC3 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Airwell RC3

Airwell RC3 Bedienungsanleitung - Deutsch - 9 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info