638708
5
Zoom out
Zoom in
Vorherige Seite
1/9
Nächste Seite
OPERATION
OPERATION
HOW TO SET THE PRESENT TIME
1. Press the SET button for five seconds. The
time indication alone ashes.
2. Press the + or - buttons until the present time
is displayed.
3. Press the SET button to stop the indication
ashing.
COOLING
Verif y th a t t h e u n i t i s
connected to the main
power and the STANDBY
lamp is light up.
1. Set the MODE selector
to COOL .
2 . P r e s s t h e O N / O F F
button and switch the
airconditioner ON.
3 . P r e s s t h e T E M P.
b u t t o n s t o s e t th e
desired temperature
(the temperature range
is between 30°C max.
and 16°C min.).
THE DISPLAY SHOWS THE
SELECTED TEMPERATURE.
4. Press the FAN SPEED button to select the fan
speed.
5. Press the FLAP buttons and adjust the air
flow direction as desired(see adjustment of
air ow). Make sure that the remote control is
switched on.
HEATING
1. Set the MODE selector to HEAT .
2. Press the ON/OFF button and switch the air
condioner ON.
3. Press the TEMP. buttons to set the desired
temperatur e ( th e temperature ran ge is
between 30 °C max. and 16 °C min.).
THE DISPLAY SHOWS THE
SELECTED TEMPERATURE.
4. Press the FAN SPEED button to select the fan
speed.
5. Press the FLAP buttons and adjust the air
flow direction as desired(see adjustment of
air ow). Make sure that the remote control is
switched on.
NOTE
For several minutes after the start of heating
operation, the indoor fan will not run until the
indoor heat exchanger coil has warmed up
sufciently. This is because the COLD DRAFT
PREVENTION SYSTEM is operating.
When the outdoor temperature is low, frost or
ice may appear on the heat exchanger coil,
reducing the heating performance. When this
happens, a microcomputer defrosting system
operates. At the same time, the fan in the indoor
unit stops and the OPERATION lamp is ashing
until defrosting is completed. Heating operation
restarts after several minutes. (This interval will
vary slightly depending on the room and outdoor
temperature).
DEFROSTING OF HEAT EXCHANGE OUT
DOOR UNIT “STANDBY”
HEATING PERFORMANCE
A heat pump conditioner heats a room by taking
heat from outside air. The heating efciency will
fall off when the outdoor temperature is very
low. If enough heat is not obtained with this air
conditioner, use another heating appliance in
conjunction with it.
TIMER
IFEEL
SLEEP
SET
CLEAR
ROOM
MODE
HOUR
TEMP
4
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Airwell RC3 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Airwell RC3

Airwell RC3 Bedienungsanleitung - Deutsch - 9 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info