Bedienungsanleitung Faber Hemmet (Seite 7 von 52) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

706554

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

- 1 -

General.

Unpack the heater carefully and retain the packaging

for possible future use, in the event of moving or

returning the  re to your supplier. The Remote Control

and batteries are packed separately in the carton.

The  re incorporates a  ame e ect, which can be used

with or without heating, so that the comforting e ect

may be enjoyed at any time of the year. Using the

 ame e ect on its own only requires little electricity.

The heater is designed for use inset into a 407mm (16”) or

457mm (18”) wide by 559mm (22”) high  replace opening

or freestanding - see also section ‘Installation Instructions’.

Before connecting the heater check that the supply

voltage is the same as that stated on the heater.

Please note: Used in an environment where background

noise is very low, it may be possible to hear a sound which

is related to the operation of the  ame e ect. This is

normal and should not be a cause for concern.

Electrical connection.

WARNING – THIS APPLIANCE MUST BE EARTHED.

This heater must be used on an AC ~ supply only and the

voltage marked on the heater must correspond to the

supply voltage.

Before switching on, please read the safety warnings and

operating instructions.

PLEASE RETAIN THIS USER’S GUIDE FOR FUTURE

REFERENCE

Do not put Opti-myst plastic components into a

dishwasher.

Only slide out the drawer when the water tank needs

to be  lled or a lamp needs to be changed otherwise

you will inadvertently alter the water level and the

 ame e ect operation.

Only use  ltered tap water in this appliance.

Always ensure that the appliance is sitting on a level

 oor.

If you intend not using the appliance for longer than 2

weeks, drain the water from sump and water tank and

dry the sump.

Once installed, never move this appliance or lay on its

back, without draining the water from sump and water

tank.

The water tank, sump, sump lid, tank cap and air  lters

must be cleaned once every two weeks, particularly in

hard water areas.

The appliance should never be operated if the lamps

are not working.

The lamps should be regularly inspected as described

under ‘Maintenance’ and ‘Changing lamps’.

Model: Hemmet Black & Hemmet Brass

IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE

Important Safety Advice:

When using electrical appliances, basic precautions

should always be followed to reduce the risk of  re,

electrical shock and injury to persons, including the

following:

If the appliance is damaged, check with the supplier

before installation and operation.

Do not use outdoors.

Do not use in the immediate surroundings of a bath,

shower or swimming pool.

Do not locate the heater immediately below a  xed

socket outlet or connection box.

This appliance is not intended for use by children

or other persons without assistance or supervision

if their physical, sensory or mental capabilities

prevent them from using it safely. Children should

be supervised to ensure that they do not play with

the appliance.

Do not use this heater in series with a thermal

control, a program controller, a timer or any other

device that switches on the heat automatically,

since a  re risk exists when the heater is accidentally

covered or displaced.

Ensure that furniture, curtains or other combustible

material are positioned no closer than 1 metre from

the heater.

In the event of a fault unplug the heater.

Unplug the heater when not required for long

periods.

Although this heater complies with safety standards,

we do not recommend its use on deep pile carpets or

on long hair type of rugs.

The appliance must be positioned so that the plug is

accessible.

If the supply cord is damaged it must be replaced

by the manufacturer or service agent or a similarly

quali ed person in order to avoid a hazard.

Keep the supply cord away from the front of the

heater.

WARNING: In order to avoid overheating, do not

cover the heater. Do not place material or garments

on the heater, or obstruct the air circulation around

the heater.

The heater carries the Warning symbol

indicating that it must not be covered.

Faber Opti-myst Inset Fires

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Faber Hemmet Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info