Bedienungsanleitung Florabest FLS 3000 B2 - IAN 285190 (Seite 32 von 136) (Deutsch, Englisch, Holländisch, Französisch, Portugiesisch, Spanisch)

674625

Zoom out

Zoom in

Vorherige Seite

1/136

Nächste Seite

GB IE

ing if desired. The shredding

intensity depends on the size

of the leaf material and its

residual moisture.

Uses other than those described

here may damage the machine

and put the operator at risk.

During work, ensure that the device

is not struck against hard objects,

which can cause damage. Do

not suck up any solid bodies such

as stones, branches or pieces of

branch, r cones or similar, since

these can damage the device, in

particular the shredding mechanism.

Repairs of this type are not

covered by the guarantee.

Blowing operating mode:

For safety reasons, make

sure that the protective cover

(

K L M N O P Q R S T

U V W X Y Z

A B C D E F G H I J

7) is mounted on the suc-

tion opening.

• You get optimal results when you use

the blower with a separation distance

to the ground of 5 -10 cm.

• Begin work with the highest blowing

power, in order to rapidly pile up the

leaves lying around. Select a lower

blowing power to compact the previ-

ously piled up leaves.

• Before blowing, loosen leaves adhering

to the ground with a broom or rake.

• The guide rollers at the end of the tube

make it easier to work on at surfaces.

Suction operating mode:

For safety reasons, both suc-

tion tube sections and the

collection bag must be cor-

rectly mounted before you

can start the device.

• Always hold the device tight with both

hands during operation: use the handle

(

K L M N O P Q R S T

U V W X Y Z

A B C D E F G H I J

3) and the additional

handle (

K L M N O P Q R S T

U V W X Y Z

A B C D E F G H I J

10) for this.

• Make sure the volumes of leaf material

sucked in at one time are not too large.

This will avoid clogging of the suction

tube (

K L M N O P Q R S T

U V W X Y Z

A B C D E F G H I J

16) and blockage of the impel-

ler wheel.

To reduce wear on the collection

bag, do not drag it along the

ground while working.

Overload protection: The motor

will cut out immediately if overloaded.

Turn the leaf vacuum off and remo-

ve the mains plug. Then check whe-

ther the impeller is blocked or the

collection bag clogged and remove

the obstacles if they are.

The tool cannot be used until it has

completely cooled down again.

Emptying the collection bag:

With full collection bag, the suction pump-

ing capacity decreases considerably and

the collection bag must be emptied when

the bag is full or interferes with the suction

capacity of the device.

1. Turn off the device and wait until

the impeller has stopped.

2. Unplug the device.

K L M N O P Q R S T

U V W X Y Z

A B

C D E F G H I J

3. Remove the attachment eyes (15)

from the holding points (19).

Release the collection bag by

pressing the locking button (8).

4. Open the zip-fastener on the collec-

tion bag and empty it completely.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Florabest FLS 3000 B2 - IAN 285190 Seite 32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info