744394
16
Zoom out
Zoom in
Vorherige Seite
1/19
Nächste Seite
30
31
DK ENG
4. When you can see that the chimney is hot enough to draw
(after 5-10 minutes), close the door. If all the necessary condi-
tions are met, a thick layer of embers will have been formed in
the combustion chamber after another 15-20 minutes.
5. Re-stoking should normally be carried out while embers
still remain. Distribute the embers in the bottom, ensuring
that most of them are at the front of the stove.
6. Place 2 pieces of wood of 0.5-0.7 kg each and approx. 25-
30 cm long over the embers in a single layer, with a distance
of approx. 1 cm.
7. Open the air supply to maximum and close the door; the
fresh wood will then ignite within a couple of minutes.
8. Reduce the amount of combustion air to the desired po-
sition, and optimal combustion will continue until there are
glowing embers in the bed.
Make sure that there is always enough air (oxygen) to
maintain clear, lasting ames when, and after, reducing
the amount of combustion air.
During the nominal test, the stoking interval was 60-70 minutes.
9. A new portion of wood can be added by repeating steps
5 & 6.
The stove door should normally be opened gently the rst
2-3 cm, then you should wait until the pressure has equal-
ised before opening the door all the way. This technique
will prevent smoke from getting out, particularly when
there is a poor draugt.
Once the wood has burned out, it becomes glowing char-
coall. If a good layer of embers has already formed on top
of a sucient layer of ash, the stove can keep warm for a
very long time.
Important!
It is important that the fresh quantity of wood starts
to burn quickly. To ensure the fuel lights quickly, open
the combustion air to max. or leave the door ajar to
allow in the amount of air needed to light the wood.
If, however, the wood only smoulders, there will be a
strong build-up of smoke, which at worst can cause
an explosive ignition of the ue gases with the risk
of material damage and personal injury.
The stove door should never be opened when the stove is being red vigorously.
Refuelling on to a low re bed
If there is insucient burning material in the rebed to light a new fuel charge, excessive
smoke emission can occur. Refuelling must be carried out onto a sucient quantity of glow-
ing embers and ash that the new fuel charge will ignite in a reasonable period. If there are
too few embers in the re bed, add suitable kindling to prevent excessive smoke :
Fuel overloading
The maximum amount of fuel specied in this manual should not be exceeded, overloading
can cause excess smoke.
Operation with door left open
Operation with the door open can cause excess smoke. The appliance must not be oper-
ated with the appliance door left open except as directed in the instructions.
We would strongly recommend that you do not leave your stove alit at night. It
harms the environment and constitutes very poor use of the wood as the gases
in the wood do not ignite at the low temperature, but settle as soot (unburned
gases) in the chimney and stove. Extreme conditions, such as poor draught in the
chimney, large quantities of wood or wet wood, may in the worst-case scenario
cause an explosive ignition.
When ring in the summer period, when there is minimal need for heat, the combustion
will be poor. The stove provides too much heat so the combustion should be reduced.
But always remember to make sure that there are lasting ames until the wood be-
comes charcoal. If you want a weaker re, stoke up using less wood.
If you re the stove using wet wood, a lot of the fuel’s thermal energy will be spent
forcing the water out of the wood, without releasing any heat to the stove. This
incomplete combustion results in a layer of soot being left in the stove, pipe and
chimney.
Comparison between ring with wood and oil:
Type of wood (moisture content 20%) No. of cubic metres per 1000 litre oil
Oak
Beech
Ash
Sycamore
Birch
Elm
Common spruce
Silver r
7,0
7,0
7,2
7,5
8,0
8,9
10,4
10,9
16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Morso 4300 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Morso 4300

Morso 4300 Bedienungsanleitung und Installationsanweisung - Deutsch - 11 seiten

Morso 4300 Bedienungsanleitung und Installationsanweisung - Holländisch, Französisch - 36 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info