493489
8
Zoom out
Zoom in
Vorherige Seite
1/14
Nächste Seite
10 +12V TRIGGER IN
With this input triggered by a 12V DC supply, the M51 can be switched
ON remotely from standby mode by compatible devices such as
ampliers, preampliers, receivers, etc. If the 12V DC supply is cut o,
the M51 will return to standby mode.
Connect this +12V Trigger input to the remote devices
corresponding +12V DC output jack using a mono cable with
3.5mm male plug. The controlling device must be equipped with a
+12V trigger output to use this feature.
WARNING
The front panel Standby button is disabled as long as the male plug of
the mono cable (with or without +12V DC) is connected to M51’s +12V
TRIGGER IN. Unplug the mono cable for the M51 to be normally switched
ON (or back to standby mode) using the front panel STANDBY button.
11 IR IN
This input is connected to the output of an IR (infrared) repeater
(Xantech or similar) or the IR output of another component to allow
control of the M51 from a remote location.
12 POWER
Supply the AC mains power to the M51.
When the POWER switch is set to ON position, the M51 goes to
standby mode as shown by the amber status condition of the
Standby LED. Press the front panel Standby button or remote
control’s [ON] button to switch ON the M51 from standby mode.
If you intend not to use the M51 for long periods of time (such as
when on vacation), switch o the POWER switch.
With POWER switched o, neither the front panel Standby button
nor remote control’s [ON] button can activate the M51.
13 AC MAINS INPUT
The M51 comes supplied with two separate detachable mains
power cord. Select applicable mains power cord pertinent to your
region’s requirement.
Before connecting the plug to the mains powers source, connect
rmly rst the other end to M51’s AC Mains input socket.
Always disconnect the mains power plug from the mains power
source rst, before disconnecting the other end from the M51’s AC
Mains input socket.
14 FUSE HOLDER
Only qualied NAD service techicians can have access to this fuse
holder. Opening this fuse holder may cause damage thus voiding
the warranty of your M51.
IDENTIFICATION OF CONTROLS
REAR PANEL
8
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSK A РУССКИЙ
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für NAD M 51 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von NAD M 51

NAD M 51 Bedienungsanleitung - Deutsch - 14 seiten

NAD M 51 Kurzanleitung - Englisch - 2 seiten

NAD M 51 Bedienungsanleitung - Holländisch - 14 seiten

NAD M 51 Bedienungsanleitung - Französisch - 14 seiten

NAD M 51 Bedienungsanleitung - Italienisch - 14 seiten

NAD M 51 Bedienungsanleitung - Spanisch - 14 seiten

NAD M 51 Bedienungsanleitung - Schwedisch - 14 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info