POWDP2550 EN
Copyright © 2021 VARO P a g e | 10 www.varo.com
▪ Place a protractor at the side of the saw blade and table, if the angle is not 45° bevel
angle. Adjusting the height of the adjustment screw until the bevel angle is the correct
angle. Finally tighten the nut and check the angle once more.
10.7 Switching ON / OFF
For your safety use both hands to switch the power tool on and off.
▪ Insert battery (27).
▪ Unlock the lock-off button and depress the on/off switch (10) in the direction of the handle.
The saw blade rotates as long as you keep the switch engaged.
▪ When you want to turn off the machine, you have to release the on/off switch (10).
10.8 Dust bag
To attach the dust bag (15), fit it onto the dust extraction adapter. When the dust bag is about
half full, remove the dust bag from the tool and empty it.
10.9 Sawing
Make sure the saw blade doesn’t block while you are sawing. It causes
damage to and burning of the motor. If there is a blockade of the saw blade,
please loosen the switch immediately to prevent damage at the motor.
▪ Clamp the work piece firmly.
▪ Set the required horizontal mitre angle or the required vertical bevel angle.
▪ Switch on the power tool.
▪ Move the handle (2) slowly downwards.
▪ Saw trough the work piece.
▪ Switch off the power tool.
▪ Wait until the saw blade (12) has come to a complete standstill before removing the work
piece.
10.10 Sawing special work pieces
Curved or round work pieces need to be secured against slipping.
Make sure there is no gap between the work piece and the fence (5) or the saw table (7).
10.11 Replacing the saw blade (Fig. 3)
Remove the battery before working on the saw blade.
Wait a while before touching the saw blade. It can be very hot.
The teeth of the saw blade are very sharp.
▪ Pull the mitre saw downwards and lock it in the lowest position by pulling the retaining pin
and turn a quarter turn until the retaining pin engages.
▪ Allow the mitre saw cutting head to rise to the upright position
▪ Loosen the cover plate screw.
▪ Press the spindle lock (17)
▪ Tilt the cover plate upwards in order to make the axle bolt accessible.
▪ Press the spindle lock button, holding it in firmly while turning the blade wrench clockwise.
The spindle lock will engage after turning the wrench. Continue to hold the spindle lock
button to keep it engaged, while turning the wrench clockwise to loosen the spindle bolt.
▪ Remove the lock bolt, outer flange (c), saw blade (b) and inner flange (a).
