Bedienungsanleitung Powerplus POWXG9008 (Seite 6 von 13) (Englisch)

582181

Zoom out

Zoom in

Vorherige Seite

1/13

Nächste Seite

POWXG9008 EN

To ensure appliance safety, use only original spare parts from the manufacturer or approved

by the manufacturer.

WARNING: High Pressure hoses, fittings, and couplings are important for the safety of the

appliance. Use only fittings and couplings recommended by the manufacturer.

Do not use the appliance, if a supply cord or important parts are damaged, e.g. safety devices,

high pressure hoses, trigger gun.

WARNING: Incorrect fuels shall not be used as they may prove hazardous.

WARNING: Do not use combustion engine powered appliances indoors unless adequate

ventilation is assessed by national labour authorities.

WARNING: Ensure that any exhaust emissions are not in the vicinity of air intakes.

7 SAFETY WARNINGS GASOLINE

WARNING: Use extra care in handling fuels. They are flammable and the vapours are

explosive. The following points must be observed.

 Use only an approved container.

 Never remove the fuel cap or add fuel with the power source running. Allow engine

exhaust components to cool before refuelling.

 Do not smoke.

 Never refuel the machine indoors.

 Never store the machine or fuel containers inside, where is an open flame, such as a

water heater.

 If fuel is spilled, do not attempt to start the power source, but move the machine away

from the area of spillage before starting.

 Always replace and securely tighten the fuel cap after refuelling.

 If the tank is drained, this should be done outdoors.

8 SAFETY FEATURES

8.1 Thermal relief valve

A thermal relief valve is provided to protect the pump from overloading if the spray gun is

closed for an extended length of time or the nozzle becomes plugged. However, it is intended

to be used as a backup system and avoid the overheating of the pump.

Switch the pressure washer "OFF", if it will not be used for longer than five minutes. This

reduces wear, prevents fuel consumption and extends the live of the pump by avoiding heat.

8.2 Safety lock off latch

To prevent accidental discharge of high pressure water, the safety latch on the trigger should

be engaged whenever the pressure washer is not in use (refer to operating instruction).

9 ASSEMBLY INSTRUCTIONS

Remove all packaging materials from the unit. Check the main unit, its components and all

accessories for loss and transport damages.

9.1 Assembly of the foot (Fig. 1)

Parts needed: 1 foot and 1 M8 lock nuts

9.2 Assembly of the handle (Fig. 2)

Install upper frame onto the lower frame and pressing down firmly until the two pins snap in

pace.

9.3 Assembly of the upper and lower lance hook (Fig. 3)

Attach the upper lance hook: install two plastic rivets, you may need to tap with a hammer to

seat the lock pin.

Attach the lower lance hook: install the M6 screw & lock nut, wrench tighten unitl the nut is

snug.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Powerplus POWXG9008 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Powerplus POWXG9008

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info