581328
7
Zoom out
Zoom in
Vorherige Seite
1/8
Nächste Seite
11
12
17
18
- AA SIZE +
- AA SIZE +
System Type
Gas - Standing Pilot
Gas - Electronic Ignition
Gas - Fire Boiler
Gas - Millivolt System
Oil - Fire Boilers
Oil - Fire Furnace
Electric Furnace
Electric Air Conditioner
Baseboard Electric Heater (120/240V)
Heat Pump/Multi-Stage equipment
Compatible with THM302M / THM303M
Yes
Yes
Yes
Yes
Yes
Some models
Some models
No
No
Two AA size batteries (included)
Wire Stripper/Cutter
(If necessary, to strip the wires)
Level
(If necessary, to level the thermostat)
Masking Tape
(To wrap the exposed wires temporarily and labeling
the disconnected wires)
Hand Power Drill with a 3/16 inch bit
( If necessary, to drill holes on the wall )
Cross (Phillips) screwdriver
Yes
Pre-Comfort Recovery
This thermostat is equipped with a ‘Pre-Comfort Recovery’ system that will activate the heating or cooling in
advance of the actual set program time so that the room will be at the desired temperature at the start of the
comfort program time.
It is normal for the system to be activated earlier (up to ½ hour for heating and one hour for cooling) than the
actual set program time.
The Pre-comfort Recovery can be disabled if desired. Please refer to "Optional Settings".
Usage Monitor
The thermostat tracks the system "ON" time; the time the heating/cooling equipment is running.
Press USAGE once to view USAGE TODAY;
Press USAGE again to view USAGE THIS WEEK.
USAGE TODAY automatically resets itself daily at real-time 00:00
USAGE THIS WEEK automatically resets itself at the end of the week at real-time 00:00
A new week begins Monday morning.
Filter Change
The FILTER CHANGE indicator will display on the LCD screen when the system "ON" time (HEAT or COOL)
has accumulated to approximately 500 hours. It is an indication that the filter should be changed at this time.
To reset the FILTER CHANGE counter press and hold USAGE for 3 seconds until the appears momentarily.
This brings the counter back to zero.
Optional Settings
Below is the list of optional settings:
- 12/24 Hour display format.
- Heat Cycle Rate (select the cycle rate to match the heating equipment).
- Pre-comfort Recovery ON or OFF.
- Backlighting ON or OFF.
To begin, press and hold SET CLOCK for 3 seconds.
SET OPTION symbol will appear and either 12Hr or 24Hr will flash.
- Select your preference of 12Hr or 24Hr by pressing UP or DOWN.
Press SET CLOCK to move on to Cycle Rate.
- Choose from Cr0 to Cr4 by pressing UP or DOWN. See Chart 1
- Factory default is Cr3.
Press SET CLOCK to move on to Pre-comfort Recovery ON/OFF
and Backlight ON/OFF settings.
- Choose from OP0 to OP3 by pressing UP or DOWN. See Chart 2
- Factory default is OP3
The backlight only comes ON in the dark.
If the Backlight is ON (enabled), any key press will turn the backlight
ON for 8 seconds in the "dark".
Compatibility
Generally, equipment with low voltage control is compatible with the THM302M / THM303M thermostat.
For details on compatibility of your particular equipment, please call our technical assistance line.
* Not compatible with any 120/240 volt circuit.
Installation
The following tools may be required for installation:
See below to select a suitable place for the new thermostat installation. And refer to "Replacing Old
Thermostat" section to replace old thermostat.
Cr
Cr0
Cr1
Cr2
Cr3
Cr4
System Cycles per Hour
-
Hydronic heat, condensing gas furnaces
Commercial Unit
Gas or oil forced air (default)
Electric Heat
disabled
2
3
5
7
OP
OP0
OP1
OP2
OP3
Options
Both Pre-comfort Recovery and Backlight are OFF
Only Pre-comfort Recovery - ON; Backlight - OFF
Pre-comfort Recovery - OFF; Only Backlight - ON
Both Pre-comfort Recovery and Backlight are ON
Chart 2
Chart 1
7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für UPM THM302M wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von UPM THM302M

UPM THM302M Bedienungsanleitung - Französisch - 8 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info