5
Copyright U.S. Blaster Europe BV © - Delft - Netherlands
ENG
SPECIFICATIONS :
INPUT :
MICRO : 2Kohms / -60dB
PHONO : 47Kohms / -60dB
LINE : 47Kohms / -20dB
RETURN : 47Kohms / -10dB
STEREO : 10Kohms / -10dB
OUTPUT :
MASTER A et B : 600 Ohms / +4dB
SEND : 600ohms / 0dB
REC : 600ohms / 0db
Puissance Sortie : 3mW, max 10mW
MICRO TONE CORRECTOR :
Haute : 10KHz +/-12%
Basse : 100 Hz +/- 12%
FREQUENCY CHARACT.: 20Hz-20KHz +/- 0~1dB
DISTORTION : < 0.01 % ( 20HZ – 20KHz )
GRAPHIC EQUALIZER : 63Hz
250Hz
1KHz
4KHz
16KHz
ECHO : 80Hz – 16KHz
DELAY ECHO : 24.6 – 393.2ms
22. POWER SWITCH
Press this switch to turn the power ON, press again to turn the power OFF. When operating
this switch, be sure that all controls are set at minimum position.
23. VU-METER
The VU-Meters indicate the left and the right levels of the Master output.
24. BALANCE MASTER A AND B
This control adjusts the master output left/right balance
25. SEND AND RETURN EFFECT ADJUSTEMENT
The EFF-SEND potentiometer is used to adjust the level od the SEND effect output.
The EFF-RET potentiometer is used to adjust the level of RETURN input signal.
NOTE: You don’t hear the echo on the SEND output.
26. MASTER LEVEL ADJSUTEMENT
Used to adjust the level of the master outputs.
27. HEADPHONE INPUT
Stereo input jack for headphone (Ø 6,35mm - 1/4”). Before connecting, make sure the rota-
ry is under 5.
28. REGLAGE DELAI ECHO
Used to adjust the delay of the echo effect.
Note : the echo only acts on master and REC outputs. It doesn't act on the SEND output. To
hear the echo, you must adjust the level of the SEND output even though this last is not
connected