634250
4
Zoom out
Zoom in
Vorherige Seite
1/4
Nächste Seite
Heater cuts out automatically
Black smoke is emitted from the heater
Cause
Cause
Remedy
Remedy
Troubleshooting Error code output on combination timer or control element
NOTE for ADR mode only:
!
If an error occurs, first check the fuse and plug connections to ensure that they are in
perfect condition and connected correctly.
If the action described below does not rectify the error, have the heater checked by
Webasto-trained personnel.
If the system is fitted with a combination timer, when an error occurs an error code is
output on the timer's display until the heater has been rectified.
If the system is fitted with a control element, when an error occurs an error code is output
by the indicator/error code display flashing. After a burst of fast flashes the error code will
be output by a sequence of long flashes, the number of which is shown in the table
below. The error code will continue until the heater is reset.
Meaning of error code
After an ADR cut-out or the application of operating voltage by switching on the main
vehicle switch and setting the control element to ”ON” the control unit will be set to
the “Fault cut-out” position.
Before the heater can be restarted the control element must be set to “OFF” or the
immediate heat button on the combination or standard timer must be pressed.
No combustion after start
and repeat start
Flame extinguishes during
operation
Heater overheats
Indicator flashes
Vehicle voltage too low
Combustion air and/or
exhaust system blocked
Switch the heater off (wait at least 2 seconds) and
then on again
Switch the heater off (wait at least 2 seconds) and
then on again
Check that the hot air can flow freely.
Allow the heater to cool.
Switch the heater off (wait at least 2 seconds) and
then on again
Charge battery
Switch the heater off (wait at least 2 seconds) and
then on again
Check combustion air and exhaust system for
blockages
F00
F01
F02
F03
F04
F06 T
F07
F08
F09
F10
F11
F12
Control unit error
No start (after 2 attempts to start)
Flame failure (at least > 5)
Undervoltage or overvoltage
Premature flame recognition
emperature sensor interrupt or
temperature sensor short circuit
Metering pump interrupt or
metering pump short circuit
Fan motor interrupt or
fan motor short circuit or
fan motor incorrect speed
Glow plug interrupt or
glow plug short circuit
Overheating
Overheating sensor interrupt or
overheating sensor short circuit
Heater lock-out
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

webasto-airtop-5000

Suche zurücksetzen

  • wie stelle ich die Heizung an? Muss ich da einen Absperrhahn öffnen? Eingereicht am 29-9-2023 18:41

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Webasto AIRTOP 5000 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Webasto AIRTOP 5000

Webasto AIRTOP 5000 Bedienungsanleitung - Deutsch - 4 seiten

Webasto AIRTOP 5000 Bedienungsanleitung - Holländisch - 25 seiten

Webasto AIRTOP 5000 Bedienungsanleitung - Französisch - 4 seiten

Webasto AIRTOP 5000 Bedienungsanleitung - Italienisch - 4 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info