32279
8
Zoom out
Zoom in
Vorherige Seite
1/76
Nächste Seite
8
Unpacking & Checking Contents
To avoid injury from unexpected starting or
electrical shock, always remove plug from
wall outlet when tool is not in use.
Model 1800 Scroll Station is shipped complete in one carton.
Separate all “loose parts” from packing materials and check
each item with the “Packing List” to make sure all items are
accounted for before discarding any packing material.
If any parts are missing, do not attempt to
operate Scroll Station, plug in the power cord
or turn the switch on until the missing parts are obtained and
are installed correctly.
WARNING
!
WARNING
!
Packing List
Item Description Qty.
A 18” Scroll Station ......................................................1
B Owner’s Manual........................................................1
C Parts Bag (containing)..............................................1
D Side Table with Side Miter......................................1
E Flat Head Screws....................................................2
F Wing Knobs ............................................................2
G. Flip-up Guard..........................................................1
Allen Wrench (2 mm, 2.5 mm & 4 mm)..................1
Drive Screw for Flex Shaft Attachment ..................1
Adaptor for future additions ....................................1
Spacer ....................................................................2
O Ring ....................................................................2
Drive Nut ................................................................1
Blades ............................................................................12
To remove protective coating from the table surface, moisten
a soft cloth with kerosene or WD-40 and wipe off coating. Do
not use acetone, gasoline or lacquer thinner for this purpose.
After removing protective coating, If you wish, you may apply
a coat of paste wax to the table to allow the workpiece to slide
easily across the table surface and deter rust. Wipe the table
thoroughly with a clean dry cloth.
Tools Needed
A
NOTE: Hardware to mount this Scroll Station to a bench or
leg set is NOT supplied. See ASSEMBLY-MOUNTING THE
SCROLL STATION, P
age 8, for recommended hardware
size.
IMPORTANT! If you require any assistance with these
instructions, please contact the Dremel Service Department
at:
1-800-437-3635
D
E
E
F
F
G
Figure 2. Packing List Parts
1
2
3
Combination Square Must be True
1. Use the straight edge of a 3/4" thick board (this edge
must be perfectly straight).
2. Draw a line on the board along this edge.
3. There should be no gap or overlap when the square is
flipped over in dotted position.
Combination Square (not included)
Phillips Screwdriver (not included)
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Dremel 1800 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info