Product: Ferm Belt sander/grinder
Type FBSM-150/50, art.nr. 350350
Ferm, Genemuiden, The Netherlands
Sound pressure level 76 dB(A)
In order to prevent overheating and possi-
ble damages to the engine, use the machine
intermittently, for periods of 30 minutes.
CAREFULLY READ THE INSTRUCTIONS
BEFORE YOU USE THE BELT SANDER/-
1. GENERAL SAFETY RULES
Keep the work area clean.
- A cluttered work area may cause accidents.
- Make sure the work area is well lit.
Never leave tools in the rain. Do not use tools
in damp or wet places. Never use tools near in-
flammable liquids or gasses.
Prevent electrical shock.
Keep the power cord away from heat, oil and
sharp edges. Avoid skin contact with exposed
parts of the power cord or plug. Damaged parts
must be replaced immediately.
Keep children away.
Never allow children or spectators to touch the
tools, keep them at a safe distance from the
Store tools in a safe place.
Tools that are not used must be stored in a dry
and locked placed, out of the reach of children.
Do not force the tool.
The machine will do the job better and safer at
the rate for which it was intended. Damage cau-
sed by forcing the tool is not covered by the
Use the right type of tool.
Do not use low-powered tools for heavy-duty
operations. Never use the machine other than
for its intended purpose.
Wear suitable clothing.
- Do not wear loose clothing or jewellery that
might get caught in moving parts;
- Never wear rings with protruding parts;
- Cover long hair;
Wear safety glasses, mouth and ear protection.
Wear personal protection while working.
Never carry the tool by its cable and do not tug
at the cable to pull the plug from the socket.
Keep the cable away from heat, oil and sharp
Always clamp the work.
Always clamp the work against the bench.
work on objects that are too small to hold.
- Do not over each. Be sure of your footing and
balance at all times;
- Do not over reach on ladders or scaffold.
Maintain the tool with care.
- The tool works best and safest if it is kept clean.
- Observe the instructions for maintenance and
changing accessories. Keep the tool dry and free
from oil and grease.
Disconnect the machine.
Disconnect the machine when you do not use it,
before cleaning and when changing accessories
Remove wrenches from the machine.
Before starting the machine, make sure to
remove wrenches and other tools.
Avoid unintentional starting.
Never carry the plugged-in machine with your
finger on the switch. Make sure the switch is off
when the machine is plugged in.
Extension cable for outdoor use.
When working outdoors use only extension cables
suitable for this purpose and marked as such.
When using machines with earth connection, use
an extension cable with earth connection.
Watch what you are doing, use your common
sense, do not operate the tool when you cannot
concentrate on the job.
Check the machine for damage.
- Before starting the machine, check that all safety
devices operate properly;
- Make sure all moving parts are in good working
order. Check the machine for any broken or