11/2015 – V 1.7
Trademarks
The Bluetooth
®
word mark and logos a
use of such marks by TARGA GmbH is under
USB is a registered trademark.
Other namegistered trademarks of their respective o
Introduction
Thank you for purchasing a SilverCrest Bluetooth
®
audio transmitter/receiver SBR 3.0
referred to as SBR 3.0 A1.
Intended use
This SBR 3.0 A1 is an informce and enables you on the one hand to transmi
audio signals wirelessly, for example, from your stereo system to a Bluetooth
®
headset. You can also
wirelessly transmit, for example, music files that are on your smartphone to a stereo system and play
them back on the system. T
company, but solely for private purpoother use
®
device
complies with all res and directiany modification to the Blueto
®
audio transmitter/receiver that was not approved by the m
standards is no longer guara do
damage or faults in such cases.
Please observe the regulations a
Supplied items
Take the device and alkaging
that all parts are complete a
please contact the manufactur
A. Bluetooth
®
audio transmitter/receiver SBR 3
B. RCA
C. USB charging cabl
D. Audio cable (3.5mm jack
E. USB power supply
F. Adapter (3.5mm to 6.3mm)
G. These operating instructions (symbo
Technical data
SBR 3.0 A1
Input voltage / 5V / max. 500mA
Profile support A2DP
Bluetooth
®
specification V3.0 + EDR
Range max. 10 metres
Internal battery Li-Ion 700mAh
Charging time (with supplie approx. 8 hours
Operating time when the b min. 8 hours
Operating temperat 0°C to +40°C
Operating air humidity
max. 85% rel.
(non-condensing)
Dimensions (W x approx. 5.9 x 2.4 x
Weight approx. 52g
USB power supply
Type KPTEC / K05S050100G
Input voltage / 100 – 240V , 50/60Hz / 0.2A
Output voltag 5V / 1.0A
Protection class II
Weight (inclu approx. 55g
The technical databe changed without no
Safety instructions
Before using the SBR 3.0 A1 (A) for the first time, please read the following instructions carefully even
if you are familiar with using electronic deore these operating instructions in a safe place for
future reference. If you pass on the SB
operating instructions. They are
DANGER! This symbol
dangerous situation which, if not prevenuld result in serious injury or even death.
WARNING! This symbol in conjun
information for safe operation of the de
This symbol warns of health risks due to high volume.
This symbol indicates other important in
Operating environment
The SBR 3.0 A1 (A) is not designed for use in environmenerature or humidity, and
must be kept free from dust. es and opera
85% rel. hum
the rubber feet of t
DANGER! Ensure th
no direct heat sources (e the SBR 3.0
otherwise
the SBR 3.0 A1 (A) is not exposed to direct sunlight or bright artificial light because it may be
damaged otherwise
no fire sources (e.g. burning can
fire
no foreign objects penetrate the device because there is a ri
contact with dripping water an
is never operated near water; in partic
filled with liquids, e.e SBR 3.0 A1 (A); there is a risk of fire or a short
circuit)
the SBR 3.0 A1 (A) is never covered while it is charging
the SBR 3.0 A1 (A) is switched off immediately if there are any unusual sounds or if smoke is emitte
from it
the SBR 3.0 A1 (A) is not exposed to extreerature fluctuations as this could resul
condensation and electrical short circuita risk of fire. If the SBR 3.0 A1 (A) was subjecte
to extreme temperature fluctuations, however (approx. 2 hours) until it has reached am
temperature before
all cables are alwady is obstructed or can trip over th
a risk of injury.
the USB power supply (E) is only inserted in a suitab
never covered. The USB opened or handled with wet hand
risk of a fatal electri
the USB power supply (E) is always disconnected fr
thunderstorm. Also if there
DANGER! Children and persons with
disabilities
Electricdren. This device ca
and older and by persons with resensory abilities, disorders or lack of
experience and kn
3.0 A1 and understand the resulting risks. Children should pervised to en
not play witnance must not be carried out b
supervision.
Always keep pl
It poses a suffocation risk!
DANGER! Radio inte
Turn the device off in aircraft, ooms or in the vicinity of medical electronic system
The transmitted radio waves can impair the functionay of sensitive devices. Keep the device at least
20cm away from any pacrdioverter defibrillators, since th
functioning of the pacemaker adio waves. The transmitted radio waves can
interference in hear0 A1 in the vicinity of flammable gases or in a
potentially explosiv
because the transmitted radio waves can cause an eosion or a fire. The range of the radio waves is
dependent on conent. In th
connection, it is also possible for unauthorised third parties to recei
responsible for radio or televisionused by unauthorised changes to this device.
addition, TARGA assumes no responsibility for the replacement or exchange
devices not indicated by TARGA GmbH. The user is solely responsible for the elimination of
interference caused by su
devices.
DANGER! Risk of explosion
The device must not be
Note on disconnecting from the mains
Even if you have disconnefrom the USB power supply
be consumed by the USB power supply (E) as lo it is plugged into a mai
unplug the USB power supp
Maintenance / cleaning
The SBR 3.0 A1 (A) does not contain any parts that r
3.0 A1 (A) does not bever open the housing of the device.
WARNING! Clean the SBR 3.0 A1 (ly damp cloth if it becomes
Do not use any solvents, corrosive or gaseous cleaning agents
could be damaged.
Overview of the controls
1
Button
2
LED (blue)
3
LED (red)
4
LED (green)
5
LED (yellow)
6 Mode selection switch RX-Off-TX
7
Micro USB socket
8
Audio Out socket (3.5mm)
9
Audio In socket (3.5mm)
